Effect of Laser Power on Component Strength in Laser Sintering

Prototyping or model making is one of the important steps to finalize a product design. It helps in conceptualization of a design. Before the start of full production a prototype is usually fabricated and tested. RP processes namely Stereo-lithography (SL), Selective Laser Sintering (SLS), Fused Deposition Modelling (FDM) and Laminated Object Manufacturing (LOM) are described. In Selective Laser Sintering (SLS) process, fine polymeric powder like polystyrene, polycarbonate or polyamide etc. (20 to 100 micrometer diameter) is spread on the substrate using a roller. Before starting CO2 laser scanning for sintering of a slice the temperature of the entire bed is raised just below its melting point by infrared heating in order to minimize thermal distortion (curling) and facilitate fusion to the previous layer. The laser is modulated in such a way that only those grains, which are in direct contact with the beam, are affected. Once laser scanning cures a slice, bed is lowered and powder feed chamber is raised so that a covering of powder can be spread evenly over the build area by counter rotating roller.

Autorentext

Dr. Chandan Deep Singh is working as assistant professor in department of mechanical engineering, Punjabi University, Patiala. He has completed his Ph.D. in 2016. He has guided around 50 students for M.Tech. thesis and has around 90 publications to his name.