Investigation Effect Of Machining Parameters In Turning AISI D2 Steel

The aim of the present work is to investigate the effect of process parameter on surface finish and material removal rate to obtain the optimal setting of these process parameters and the ANOVA is also used to analysis the influence of cutting parameters during machining. L27 experimental runs based on an orthogonal array of full factorial method were performed. Additionally the ANOVA is also applied to identify the most significant factor. This work presents an experimental investigation of influence of the three most important machining parameters of Speed, Feed and Depth of Cut on surface roughness during turning of AISI D2 steel. The result indicated that the process parameter cutting speed feed rate and combination of both parameters have significant effects on surface quality of turning of AISI D2 steel. From ANOVA analysis surface roughness is mostly affected by cutting speed and feed rate so that surface roughness can be improve by decreasing the feed rate as well as increasing the cutting speed up to 66 m/min and after increasing cutting speed surface roughness decrease.

Autorentext

Romil Patel trabalha como Professor Assistente no Departamento de Engenharia Mecânica do Instituto de Tecnologia da Universidade de Ganpat, Ganpat Vidyanagar, Mehsana, Gujarat, Índia.Jay Vyas trabalha como Professor Assistente no Departamento de Engenharia Mecânica do Merchant Engineering College, Basna, Mehsana, Gujarat, Índia.